Technology


Uniquely, PJUUR® offers 2 installation options for each feature to facilitate seamless integration. This for both dry construction systems (Plasterboard and Gyproc) and plaster on brick, quick construction brick or concrete. These 2 types are continued unambiguously throughout the article codes: HW or ST.

- HW -


Mounting frames for plasterboard systems, installed according to plasterboard panels of 12.5mm thickness.


- ST -


Mounting frames for brick, quick build brick or concrete, which are finished with 6mm plaster.

Material


In the technical development of the product range, all aspects were considered in order to provide a "step-by-step and easy-to-install solution". For 2 years, PJUUR® developed its own material composition consisting mainly of natural gypsum (CaSO4-2H2O / calcium sulfate dihydrate) and other all-natural additives. After various lab tests, this has resulted in a unique, high quality and very strong material composite.

 Metal and/or aluminum frames have an exponentially greater coefficient of expansion compared to plaster. These require a 2K and fiberglass finish to "limit" cracks and tears. Consequently, they cannot be finished using standard plastering processes.

Frames manufactured from plastics (e.g.: PA or Polyurethane, whether or not filled with Aluminum(tri)hydroxide), exhibit a different thermal behavior compared to plaster. These will swell (absorption of moisture into the structure) or shrink (wash-out of additives or chemical degradation under the influence of moisture, temperature and/or radiation) in a relatively short period of time. As a result, a tight finish can never be guaranteed and cracks and cracking are inevitable.

For PJUUR®, during the development of the material, the mass density ( ρ or g/cm³) and thermal expansion ( γ or 10-3m3/m3 K-1 = volumetric coefficient of expansion) were a sine qua non condition: The tolerances of ρ and γ must deviate no more than 0.5% from those of calcium sulfate dihydrate (= plaster or plasterboard).

As a result, our material composite results in frames with exactly the same density and exactly the same thermal behavior as plasterboard and/or stucco. Consequently, a perfectly finished and smooth result can be guaranteed over the long term. The material is silky smooth, very strong, heat resistant, fireproof, has similar drying characteristics and adhesion as natural gypsum, allowing it to be processed one-to-one in standard drywall systems and plaster.